Port holes siliconed into place , the other little guy will have a pipe stuck in it and will be a vent.
The port holes are where the tank will be filled, they will be accessed from either side of the camper through the new under bed storage doors.
Top of the lid where the table will be mounted got a layer of matt and epoxy.
Tank outlet fitting's.
Top view looking down at the two taps that branch off from the tank outlet. Going left, to the pump, filter and expansion tank , then to all the fixtures, and to the right, goes down through a hole in the floor, between the under body tool boxes and that will be to drain the tank.
Wifey going somewhere while I slave away!
With the water tank pretty much done I got busy with a complicated cabinet end unit that will house the heater and will also have the catalytic heater mounted to it.
heater.
Pipe holes.
Pipe run that will go to the diesel boiler, also has a vent with tap at the highest point.
Looks like this, that thing in plastic is the catalytic heater, and just above it is where that heater fan with all the pipes connected to it sits, all the pipes are inside.
Both heaters are pointed to the area where we sit, , nice!
No comments:
Post a Comment